Where Is the DCM in a 2022 Toyota Corolla Cross?

The DCM — the Data Communication Module, part of Safety Connect / Connected Services — is the module our bypass harness plugs into. Finding it is the only tricky part of the install. Pick your vehicle and we will show you where it lives and what has to come apart to reach it.

Not sure whether your vehicle even has one? Look for an SOS or Call Toyota button near the rear-view mirror or in the overhead console. No button means no DCM — and no need for the bypass harness.

Short answer

Behind the centre dash below the radio, toward the driver side.

We have not verified the disassembly for this vehicle yet - ask us before you plan the job.

Where it is

In the centre stack behind the dash, below the radio and display receiver, set toward the driver side of the stack.

How it sits: It stands upright with its long edge horizontal - the large flat face points back toward the driver.

How to get to it

We do not have a verified factory removal procedure for this vehicle yet. The location above is confirmed, but check a service manual for your exact model - or email us and we will help you plan the disassembly before you start.

No SOS button near the rear-view mirror or overhead console means the vehicle was built without Safety Connect - there is no DCM to bypass and this kit is not needed. It is NOT behind the glovebox on the passenger side.

The bypass harness for this vehicle

Our bypass kit disconnects the DCM without losing your front right speaker or the hands-free Bluetooth microphone — the two things that stop working if you simply unplug the module.

See the AHH-DCM77 DCM bypass harness »

Still cannot find it, or your trim looks different? Email us with your year, model, and a photo of your dash and we will point you straight at it.

Vehicles we have mapped so far

We are adding vehicles as we confirm them. Do not see yours? Ask us — that is how this list grows.

Looking for the harness itself? AHH-DCM77 (2020 and newer) — AHH-DCM92 (2016-2020).